Lexmark Optra S Service Manual - Page 45

4059-XXX User Error Message Explanation 36 Resolution Reduced The resolution of the page has been reduced from 600 dpi to 300 dpi in order to prevent a Memory Full error. This message can only occur if the Resolution Reduction setting is turned on. Note: 1200 dpi pages are not resolution reduced. If a 1200 dpi job runs out of memory, a Memory Full error is displayed. 37 Insufficient Collation Memory This message is displayed when the printer memory used to store pages is too full to collate the print job. 38 Memory Full This message is displayed when the printer memory used to store pages is full. 39 Complex Page This message is displayed when the page is too complex to print. 51 Defective Flash This message is displayed when the printer detects a defective flash. This error may occur at power on, or during flash format and write operations. Press Go to clear the message. The flash is marked as bad and normal operation continues. Flash operations are not allowed until the problem is resolved. 52 Flash Full This message is displayed when there is not enough free space in the flash memory to hold the resources that have been requested to be written to flash. 53 Unformatted Flash This message is displayed when the printer detects an unformatted flash at power on. Press Go to clear the message. The flash is marked as bad and normal operation continues. Flash operations are not allowed until the flash is formatted. 54 Standard Serial Error This error is displayed when a serial error (framing or parity) is detected on the standard serial port. This usually indicates the serial port is not set up correctly. 54 Serial Option X Error This error is displayed when a serial error (framing or parity) is detected on the optional serial port. This usually indicates the optional serial port is not set up correctly. Diagnostic Information 2-18