Marantz NR1501 NR1501 User Manual - English - Page 39

ENGLISH CONNECTIONS FUNCTIONS NAMES AND BASIC OPERATION ADVANCED CONNECTIONS BASIC Symptom Cause Solution When the surround mode is set to There is no sound from the surround speakers. The surround mode is set to STEREO. SURROUND = NO is selected on the SPEAKER CONFIG menu. STEREO, no sound will come from the surround speakers. Set the unit to another surround mode. Set SURROUND to YES. The PL IIx mode or other 6.1 or 7.1 channel surround sound mode has not been set as the surround See the surround mode table. mode. There is no sound from the surround back speakers. SURROUND BACK = NO is selected on the SPEAKER CONFIG menu. Set SURROUND BACK to YES or 2CH. Connection has been made to SURROUND BACK R even though the system is being used with the surround back speakers set to YES. Connect the speaker to SURROUND BACK L when SURROUND BACK is set to YES. • The subwoofer is not turned on. • Turn on the power to the • The subwoofer level is too low. subwoofer. • SUBWOOFER = NO is selected • Raise the subwoofer level. on the SPEAKER CONFIG menu. • Select SUBWOOFER = YES. There is no sound from the subwoofer. FRONT : FULL RANGE is set on When SW PLUS+ is selected as on the SPEAKER X-OVER menu, the SUB W MODE setting, the SUB W MODE: NORMAL is set bass components are played from on the SYSTEM SETUP menu, and the front speakers and subwoofer, an analog or PCM source is being and the sound heard may be played. unnatural because of interference. The playback source does not contain any LFE or sound in the low range. Cannot select the NEO:6 mode. There is no interchangeability in the input signals. Use 2-channel DTS input signals, PCM input signals or analog input signals. NIGHT mode does not function. (Only applies to units with NIGHT A source that is not recorded in Dolby Digital is being played. Use a source recorded in Dolby Digital. mode) Cannot select the The surround modes available are desired surround limited by input signal and speaker See the surround mode table. mode. settings. • The unit is connected using an • Use a digital (optical or coaxial) or analog connection. HDMI connection. A noise is • The player is conducting search generated during playback. playback of DTS- • Some inappropriate digital encoded CDs, etc. processing (level adjustment, change of sampling frequency, etc.) is happening in the player. • Noise may occur during search playback depending on the component. There is nothing wrong with the unit. • See the player's instruction manual. Page 22 38 22 8, 22 22 19, 23 38 9, 11 TROUBLESHOOTING Symptom Cause Solution Cannot play back audio like Dolby Digital or DTS. (Indicator does not light up.) • The digital signal output of the player, etc., is set to PCM. • The unit is connected using an analog connection. • See the instruction manual of the player, etc. • Use a digital or HDMI connection. • The player or other source • Connect a component (with component does not support HDMI version 1.3a or higher) Cannot play back these audio mode outputs. which supports Dolby TrueHD audio like Dolby and DTS-HD. TrueHD or DTS-HD. (Indicator does not light up.) • The audio output of the player is not set properly. • The HDMI connections have not • Set the output so that the source component will be able to output these audio modes. been performed. When playing a CD on a DVD player, Depending on the player, the digital the next track is signal may be interrupted when a If using such a DVD player, you played with part track is skipped. The start of the can play back the audio without of the beginning song may be slightly interrupted in problem by using an analog missing when track order to determine the surround connection. skipping, etc., is system. conducted. Page − 11 10 35 SETUP ADVANCED OPERATION TROUBLESHOOTING OTHERS