Marantz SR7300OSE User Guide - Page 20

ENGLISH CONNECTING AUDIO COMPONENTS CD RECORDER / MD DECK DIGITAL OUT OUTPUT L R OUT IN DIGITAL DIGITAL L L INPUT OUTPUT LR R R CD PLAYER OUT IN L L R R LR LR LR RL LR LR LR TAPE DECK ANTENNA FM (75Ω) GND AM VIDEO TV DVD VCR1 IN OUT COMPONENT VIDEO DVD DSS / VCR2 MONI OUT Y CB / PB CR / PR Y CB / PB CR / PR Y CB / PB CR / PR RS-232C DSS / VCR2 MONI MULTI TV IN OUT OUT OUT DVD VCR1 IN OUT DSS/VCR2 IN OUT S-VIDEO MONI OUT MODEL NO. SR7300 AC IN SERIAL NO. DIGITAL IN RC-5 MULTI DC OUT DIGITAL OUT RC L SL 1 2 3 4 5 6 OPT COAX IN OUT TV DVD VCR1 DSS / VCR2 CD TAPE CDR / MD MULTI R SR IN OUT IN OUT IN OUT IN OUT OUT L SL L R AUDIO R SR (AUX2) SBL C PRE OUT SBR SBL SW C 7.1CH IN SBR SW R ANL ALORG AUL DIO LR FRONT A FRONT B CENTER SPEAKER SYSTEMS FRONT A OR B, CENTER, SURROUND, SURR. BACK : MINIMUM 6 OHMS FRONT A AND B : MINIMUM 8 OHMS DIGITAL AUDIO (COAXIAL) SWITCHED UNSWITCHED 120W 1A MAX 120W 1A MAX AC OUTLET 120V 60HZ R L SURROUND SURROUND BACK RL RL DIGITAL AUDIO (OPTICAL) The output audio signal from the TAPE OUT jack and the CD-R/MD OUT jack is the sound source currently selected. Caution: • Do not connect this unit and other components to mains power until all connections between components have been completed. Notes: • Insert all plugs and connectors securely. Incomplete connections may make noise. • Be sure to connect the left and right channels properly. Red connectors are for the R (right) channel, and white connectors are for the L (left) channel. • Be sure to connect input and output properly. • Refer to the instructions for each component that is connected with this unit. • Do not bind audio/video connection cables with power cords and speaker cables will result in generating hum or other noise. CONNECTING DIGITAL AUDIO COMPONENTS • There are 6 digital inputs, 3 coaxial jacks and 3 optical jacks, on the rear panel. You can use these jacks to input PCM, Dolby Digital and DTS bitstream signals from a CD, DVD, or other digital source components. • There are one digital output with coaxial jack and one with optical jack on the rear panel. These jacks can be connected to CD recorder, MD deck. 16 • Setup the digital audio format of DVD player, or other digital source component. Refer to the instructions for each component to be connected to digital input jacks. • Use fiber optical cables (optical) for DIG-1,2,3 input jacks. Use 75 ohms coaxial cables (for digital audio or video) for DIG-4, 5, 6 input jacks. • You can designate the input for each digital input/output jacks according to your component. See page 22. Notes: • There is no Dolby Digital RF input jack. Please use an external RF demodulator Dolby Digital decoder when connecting the Dolby Digital RF output jack of the video disc player to the digital input jack. • The digital signal jacks on this unit conform to the EIA standard. If you use a cable that does not conform to this standard, this unit may not function properly. • Each type of audio jack works independently. Signals input through the digital and analog jacks are output through the corresponding digital and analog jacks, respectively.