Marantz SR7300OSE User Guide - Page 9

ENGLISH FRONT PANEL qw @1 !5 !6 !7 !8 !9 e r t y u i o !0 !1 !2 SELECTOR AV SURROUND RECEIVER SR7300 VOLUME SELECT STANDBY POWER ON/STANDBY ENTER PHONES CLEAR MEMORY TUNING F/P MODE SPEAKERS A/B 7.1CH INPUT A/D S-DIRECT MULTIROOM TV DVD VCR1 DSS/VCR2 AUX1 AUX2 CD-R TAPE CD TUNER DOWN UP MUTE ATT DIGITAL S-VIDEO AUX1 INPUT VIDEO L AUDIO R !4 !3 @0 q POWER switch and STANDBY indicator When this switch is pressed once, the unit turns ON and display appears on the display panel. When pressed again, the unit turns OFF and the STANDBY indicator lights. When the STANDBY indicator is turned on, the unit is NOT disconnected from the AC power. w SELECT (MULTI FUNCTION MODE SELECT) button Press this button to change the mode for MULTI FUNCTION control dial. e SURROUND MODE Selector & MULTI FUNCTION control dial This dial changes surround mode sequentially or select contents of OSD menu system. r ENTER (MULTI FUNCTION ENTER) button Press this button to enter the setup by MULTI FUNCTION dial. t CLEAR button Press this button to cancel the station-memory setting mode or preset scan tuning. (See page 35) y MEMORY button Press this button to enter the tuner preset memory numbers or station names. (See page 35) u TUNING (Down) / (Up) buttons Press these buttons to change the frequency or the preset number. These buttons can change setup parameter to each content in OSD menu system. (See page 35) i F/P (Frequency / Preset) button During reception of AM or FM, you can change the function of the UP/ DOWN buttons for scanning frequencies or selecting preset stations by pressing these buttons. (See page 35) o MODE button Press this button to select the auto stereo mode or mono mode when the FM band is selected. The "AUTO" indicator lights in the auto stereo mode. (See page 35) !0 MUTE button Press this button to mute the output to the speakers. Press it again to return to the previous volume level. !1 VOLUME control knob Adjusts the overall sound level. Turning the control clockwise increases the sound level. !2 ATT (Attenuate) button If the selected analog audio input signal is greater than the capable level of internal processing, PEAK indicator will light. If this happens, you should press the ATT button. "ATT" is displayed when this function is activated. The signal-input level is reduced by about the half. Attenuation will not work with the output signal of "REC OUT" (TAPE, CD-R/MD, VCR1 and VCR2 output). This function is memorized for each input function. 5