Maytag MEDB800VQ Use and Care Guide - Page 10

Put power supply cord through the strain relief. Be sure that the wire insulation on the power supply cord is inside the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Do not further tighten strain relief screws at this point. • Put direct wire cable through the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Tighten strain relief screw against the direct wire cable. Style 2: Direct wire strain relief Unscrew the removable conduit connector and any screws from a %" (19 mm) UI. listed strain relief (UI_ marking on strain relief). Put the threaded section of the strain relief through the hole below the terminal block opening. Reaching inside the terminal block opening, screw the removable conduit connector onto the strain relief threads. 4. Now complete installation following 4-wire (recommended) instructions for your type of electrical connection: 3-wire (if 4-wire is not available) Electrical Connection Options If your home has: 4-wire receptacle (NEMA type 14-30R) And you will be connecting to: A UL listed, 120/240-volt minimum, 30-amp, dryer power supply cord* Go to Section: 4-wire connection: Power Supply Cord C A. Removable conduit connector B. Hole below terminal block opening C. Strain relief threads 4-wire direct (127 ram) 3-wire receptacle (NEMA type 10-30R) A fused disconnect or circuit breaker box* 4-wire connection: I)irect Wire A UL listed, 120/240-volt minimum, 30-amp, dryer power supply cord* 3-wire connection: Power Supply Cord 3-wire direct A fused disconnect or circuit breaker box* 3-wire connection: I)irect Wire *If local codes do not permit the connection of a cabinet-ground wire, go to "Optional 3-wire connection" section. conductor to the neutral |0