Maytag MEDB800VQ Use and Care Guide - Page 13
connection, Power supply, local codes
UPC - 883049140506
View all Maytag MEDB800VQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
3° Connect ground wire (green or bare) of direct wire cable to external ground conductor screw. Tighten screw. 3-wire connection: Power supply cord Use where local codes )ermit connecting cabinet-ground D conductor to neutral wire. E B u A. External ground conductor screw B. Neutral ground wire C. Cround wire (green or bare) of power supply cord D. _/4" ( 19 ram) UL fisted strain refief E. Center silver-co/ored terminal block screw £ Neutral wire (white or center wire) 4° Place the hooked ends of the other direct wire cable wires under the outer terminal block screws (hooks facing right). Squeeze hooked ends together. Tighten screws. !! !I B C G F A. 3-wire receptacle (NEMA type lO-30R) B. 3-wire p/ug C. Neutral prong D. Spade termina/s with upturned ends E. V4" ( 19 ram) UL /isted strain relief £ Ring termina/s C. Neutra/ wire (white or center wire) 1. I.oosen or remove center silver-colored terminal block screw. 2. Connect neutral wire (white or center wire) of power supply cord to the center, silvercolored terminal screw of the terminal block. Tighten screw. A 5. Tighten strain relief screw. 6. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold- down screw. 7. You have completed your electrical connection. Now go to "Venting Requirements." A. External ground conductor screw B. Neutral ground wire C. Center silver-colored terminal block screw D. Neutral wire (white or center wire) E. 3/4" ( 19 ram) UL fisted strain refief