Maytag MGD6400TB Use and Care Guide - Page 21

Changing Modifiers and Options after pressing Start You can change an Option or Modifier anytime before the selected begins. 1. Press PAUSE/CANCEl. once. Option or Modifier 2. Select the new Option and/or Modifiers. 3. Press START to continue the cycle. NOTE: If you happen to press PAUSE/CANCEl. twice, the program clears and your dryer shuts down. Restart the selection process. Changing the Preset Dryness Level Settings If all of your loads on all Sensor Dry cycles are consistently not as dry as you would like, you may change the [)reset Dryness level settings to increase the dryness. ]his change will affect all of your Sensor Dry cycles. Your Dryness Level settings can be adjusted to adapt to different installations, environmental conditions or personal preference. There are _¢drying settings: 1 (factory preset dryness level), 2 (slightly dryer clothes, approximately 15% more drying time) and _¢(much dryer clothes, approximately 30% more drying time). 1. The Dryness Level settings cannot be changed while the dryer is running. 2. Press and hold the DRYNESS button for 5 seconds. The dryer will beep, and "CF" will be displayed for 1 second followed by the current drying setting. 3. lb select a new drying setting, press the DRYNESS button again until the desired drying setting is shown. NOTE: While cycling through the settings, the current setting will not flash, but the other settings will flash. 4. Press START to save the drying setting. 5. [he drying setting you selected will become your new preset drying setting for all Sensor Dry cycles. DRYING RACK OPTION Use the Drying Rack to dry items such as sweaters and pillows without tumbling. The drum turns, but the rack does not move. If your model does not have a drying rack, you may be able to purchase one for your model. lb find out whether your model allows drying rack usage and for information on ordering, please refer to the front page of the manual or contact the dealer from whom you purchased your dryer. NOTE: The rack must be removed for normal tumbling. Do not use the automatic cycle with the drying rack. To use the drying rack 1. Open dryer door. A. btont edge 2. Place drying rack inside dryer drum, positioning the back wire on the ledge of the inner dryer back paneh Push down on front edge of drying rack to secure at the front of the dryer. A A. Dryer rack front edge B. Dryer back panel 3. Put the wet items on top of the rack. leave space between the items so air can reach all the surfaces. NOTE: Do not allow items to hang over the edge of the rack.