Motorola DS6708-DL20291ZZR Reference Guide - Page 31
ADF Programming: Normal Data Entry. Duration of tones are short., Scanning - rs 232
View all Motorola DS6708-DL20291ZZR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Scanning 2 - 3 Table 2-1 Beeper Definitions (Continued) Beeper Sequence Indication Fast warble beep Aborting MPDF sequence. Low/high beeps Flushing an already empty MPDF buffer. ADF Programming: Normal Data Entry. Duration of tones are short. High/low beeps Enter another digit. Add leading zeros to the front if necessary. Low/low beeps Enter another alphabetic character or scan the End of Message bar code. High/high beeps Enter another criterion or action, or scan the Save Rule bar code. High/low/high/low beeps Rule saved. Rule entry mode exited. High/low/low beeps All criteria or actions cleared for current rule, continue entering rule. Low beep Delete last saved rule. The current rule is left intact. Low/high/high beeps All rules are deleted. ADF Programming: Error Indications. Duration of tones are very long. Low/high/low/high beeps Out of rule memory. Erase some existing rules, then try to save rule again. (It is not necessary to re-enter the current rule.) Low/high/low beeps Cancel rule entry. Rule entry mode exited because of an error or the user asked to exit rule entry. Low/high beeps Entry error, wrong bar code scanned. Re-enter criterion or action. All previously entered criteria and actions are retained. Criteria or action list is too long for a rule. Host Specific USB only 4 short high beeps Digital scanner has not completed initialization. Wait several seconds and scan again. Low/medium/high beeps upon scanning a USB device type Communication with the bus must be established before the digital scanner can operate at the highest power level. Low/medium/high beeps occur more than once. The USB bus can put the digital scanner in a state where power to the digital scanner is cycled on and off more than once. This is normal and usually happens when the PC cold boots. RS-232 only 1 short high beep A character is received and Beep on is enabled.