Netgear GSM7328Sv2 7000 Series Managed Switch version 8.0 CLI Reference Manual - Page 18

Managed Switch CLI Manual, Release 8.0 The command prompt changes in each command mode to help you identify the current mode. Table 5 describes the command modes and the prompts visible in that mode. Note: The command modes available on your switch depend on the software modules that are installed. For example, a switch that does not support BGPv4 does not have the Router BGPv4 Command Mode. Table 5. CLI Command Modes Command Mode Prompt User EXEC Switch> Privileged EXEC Switch# Global Config Switch (Config)# VLAN Config Interface Config Line Config Switch (Vlan)# Switch (Interface )# Switch (Interface Loopback )# Switch (Interface Tunnel )# Switch (line)# Policy Map Config Policy Class Config Switch (Config-policy-map)# Switch (Config-policy-class-map)# Class Map Config Switch (Config-class-map)# Ipv6_Class-Map Config Router OSPF Config Switch (Config-class-map)# Switch (Config-router)# Mode Description Contains a limited set of commands to view basic system information. Allows you to issue any EXEC command, enter the VLAN mode, or enter the Global Configuration mode. Groups general setup commands and permits you to make modifications to the running configuration. Groups all the VLAN commands. Manages the operation of an interface and provides access to the router interface configuration commands. Use this mode to set up a physical port for a specific logical connection operation. Contains commands to configure outbound telnet settings and console interface settings. Contains the QoS Policy-Map configuration commands. Consists of class creation, deletion, and matching commands. The class match commands specify Layer 2, Layer 3, and general match criteria. Contains the QoS class map configuration commands for IPv4. Contains the QoS class map configuration commands for IPv6. Contains the OSPF configuration commands. Using the Command-Line Interface 1-6 v1.0, July 2009