Netgear GSM7328Sv2 7000 Series Managed Switch version 8.0 CLI Reference Manual - Page 306

Managed Switch CLI Manual, Release 8.0 ip ospf network Use this command to configure OSPF to treat an interface as a point-to-point rather than broadcast interface. The broadcast option sets the OSPF network type to broadcast. The point-topoint option sets the OSPF network type to point-to-point. OSPF treats interfaces as broadcast interfaces by default. (Loopback interfaces have a special loopback network type, which cannot be changed.) When there are only two routers on the network, OSPF can operate more efficiently by treating the network as a point-to-point network. For point-to-point networks, OSPF does not elect a designated router or generate a network link state advertisement (LSA). Both endpoints of the link must be configured to operate in point-to-point mode. Default Format Mode broadcast ip ospf network {broadcast|point-to-point} Interface Config no ip ospf network Use this command to return the OSPF network type to the default. Format Mode no ip ospf network Interface Config ip ospf priority This command sets the OSPF priority for the specified router interface. The priority of the interface is a priority integer from 0 to 255. A value of 0 indicates that the router is not eligible to become the designated router on this network. Default Format Mode 1, which is the highest router priority ip ospf priority Interface Config Routing Commands v1.0, July 2009 4-58