Netgear GSM7328Sv2 7000 Series Managed Switch version 8.0 CLI Reference Manual - Page 414

Managed Switch CLI Manual, Release 8.0 show network ndp This command displays NDP cache information for the network port. Default Format Mode enabled show network ndp • Privileged EXEC • User EXEC Field Description IPv6 Address MAC Address isRtr Neighbor State Age Updated The IPv6 address of the interface. The MAC Address used. Specifies the router flag. The state of the neighbor cache entry. Possible values are: Reachable, Delay. The time in seconds that has elapsed since an entry was added to the cache. Example: The following shows example CLI display output for the command. (Switch) #show network ndp IPv6 Address MAC Address isRtr 3017::204:76FF:FE73:423A 00:04:76:73:42:3a FE80::204:76FF:FE73:423A 00:04:76:73:42:3a Neighbor Age State Updated Reachable 447535 Delay 447540 ping ipv6 Use this command to determine whether another computer is on the network. Ping provides a synchronous response when initiated from the CLI and Web interfaces. To use the command, configure the switch for network (in-band) connection. The source and target devices must have the ping utility enabled and running on top of TCP/IP. The switch can be pinged from any IP workstation with which the switch is connected through the default VLAN (VLAN 1), as long as there is a physical path between the switch and the workstation. The terminal interface sends three pings to the target station. Use the parameter to ping an interface by using the global IPv6 address of the interface. Use the optional size keyword to specify the size of the ping packet. IPv6 Commands 7-4 v1.0, July 2009