Netgear GSM7328Sv2 7000 Series Managed Switch version 8.0 CLI Reference Manual - Page 311

Managed Switch CLI Manual, Release 8.0 timers spf Use this command to configure the SPF delay time and hold time. The valid range for both parameters is 0-65535 seconds. Default Format Mode • delay-time-5 • hold-time-10 timers spf Router OSPF Config trapflags (OSPF) Use this command to enable individual OSPF traps, enable a group of trap flags at a time, or enable all the trap flags at a time. The different groups of trapflags, and each group's specific trapflags to enable or disable, are listed in Table 1. Table 1: Trapflags Groups Group errors if-rx lsa overflow retransmit rtb state-change Flags • authentication-failure • bad-packet • config-error • virt-authentication-failure • virt-bad-packet • virt-config-error ir-rx-packet • lsa-maxage • lsa-originate • lsdb-overflow • lsdb-approaching-overflow • packets • virt-packets • rtb-entry-info • if-state-change • neighbor-state-change • virtif-state-change • virtneighbor-state-change • To enable the individual flag, enter the group name followed by that particular flag. • To enable all the flags in that group, give the group name followed by all. Routing Commands v1.0, July 2009 4-63