Netgear WNDRMAC WNDRMAC User Manual - Page 75
Wireless Repeating Function, Wireless Repeater
View all Netgear WNDRMAC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
N600 Wireless Dual Band Gigabit Router WNDRMAC Wireless Repeater. The router sends all traffic from its local wireless or wired computers to a remote access point. To configure this mode, you have to know the MAC address of the remote parent access point. The WNDRMAC router is always in dual band concurrent mode, unless you turn off one radio. Be aware that if you enable the wireless repeater in either radio band, the wireless base station or wireless repeater cannot be enabled in the other radio band. However, if you enable the wireless base station in either radio band and use the other radio band as a wireless router or wireless base station, dual band concurrent mode is not affected. For you to set up a wireless network with WDS, the following conditions have to be met for both access points: • Both access points have to use the same SSID, wireless channel, and encryption mode. • Both access points have to be on the same LAN IP subnet. That is, all the access point LAN IP addresses are in the same network. • All LAN devices (wired and wireless computers) have to be configured to operate in the same LAN network address range as the access points. Wireless Repeating Function Select Advanced > Advanced Setup > Wireless Repeating Function to view or change wireless repeater settings for the router. The set of fields is the same for the 2.4 GHz or 5 GHz wireless network. • Enable Wireless Repeating Function (2.4 GHz/5 GHz). Select the check box for the 2.4 GHz or 5 GHz network to use the wireless repeating function. • Wireless MAC of this router. This field displays the MAC address for your router for your reference. You will need to enter this MAC address in the corresponding Wireless Repeating Function screen of the other access point you are using. Advanced Settings 75