NordicTrack Elite 9500 Pro Treadmill User Manual - Page 6

ASSEMBLY Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, some lubricant may be transferred to the top of the walking belt or the shipping carton. This is normal and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. Assembly requires the included hex key and your own Phillips screwdriver wrench . and adjustable Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses is the quantity needed for assembly. Note: Some small parts may have been preassembled. To avoid damaging parts, do not use power tools for assembly. Extra hardware may be included. #8 x 1/2" Ground Screw (9)-1 #8 x 3/4" Screw (1)-4 3/8" Star Washer (12)-14 3/8" Nut (11)-2 3/8" x 1 1/4" Bolt (8)-4 3/8" x 1 3/4" Bolt (6)-1 3/8" x 2" Bolt (3)-1 3/8" x 2 1/2" Bolt (4)-2 3/8" x 2 3/4" Bolt (7)-4 1. Make sure that the power cord is unplugged. Place a piece of cardboard below the rear of the 1 Frame (56) to protect the floor or carpet. Attach the Left Wheel Cap (96) to the Base (97) with two #8 x 3/4" Screws (1). Attach the Right Wheel Cap (not shown) to the right side of the Base (97) in the same way. 97 1 6 56 96 Cardboard