Onkyo 8555 Instruction Manual - Page 21
Connecting the Power Cords of Other, Components, Connecting the Power Cord - problem
UPC - 751398008313
View all Onkyo 8555 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Connecting Your Components-Continued With (Remote Interactive), you can control your -compatible Onkyo CD player, RI Dock, and so on with the receiver's remote controller. • To use , you must make an analog audio connection between the receiver and each audio component. Receiver Connecting the Power Cords of Other Components The receiver has AC outlets on its rear panel that can be used to connect the power cords of other components that you intend to use with the receiver. These components can then be left turned on so that they turn on and off as and when the receiver is turned on and set to Standby. connector Onkyo CD player, etc. connector Onkyo cassette deck, etc. connector Remote Interactive Dock, etc. Remote control cable Notes: • Push each plug in all the way to make a good connection. • Use only dedicated cables for connections (no cables are supplied with the receiver). • jacks should be connected only to Onkyo components. Connecting them to another manufacturer's component may cause the receiver to malfunction. • Some components may not support all functions. See the manuals supplied with your other Onkyo components for more information. e.g. European model e.g. North American model Caution: • Make sure that the total capacity of the components that you connect to the AC OUTLETS does not exceed the stated capacity (e.g., TOTAL 120 W). Notes: • Onkyo components connected via should be connected directly to a wall outlet, not an AC OUTLETS on the receiver. • The number of AC OUTLETS, socket type, and total capacity depend on the country in which you purchased the receiver. Connecting the Power Cord • Connect the receiver's power cord to a suitable wall outlet. Notes: • Before connecting the power cord, connect all of your speakers and AV components. • Turning on the receiver may cause a momentary power surge that might interfere with other electrical equipment on the same circuit. If this is a problem, plug the receiver into a different branch circuit. 21