Onkyo 8555 Instruction Manual - Page 22

Turning On the Receiver

Get Onkyo 8555 - TX AV Receiver PDF manuals and user guides
UPC - 751398008313
View all Onkyo 8555 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

Turning On the Receiver ON/STANDBY STANDBY indicator ON/STANDBY Turning On and Standby 1 Receiver or Remote controller Press the [ON/STANDBY] button. Alternatively, press the remote controller's [ON/STANDBY] button. The receiver comes on, the display lights up, and the STANDBY indicator goes off. To turn the receiver off, press the [ON/STANDBY] button, or press the remote controller's [ON/STANDBY] button. The receiver will enter Standby mode. To prevent any loud surprises when you next turn on the receiver, always turn down the volume before you turn it off. Changing the Input Display For the TAPE and VCR/DVR buttons, the input display name can be changed in the sequence as shown below. When the input display name has been changed for one of the buttons below, the display name for the other button cannot be changed. • TAPE button : TAPE→MD→CDR→DOCK • VCR/DVR button : VCR/DVR→DOCK 1 or Press the appropriate input selector button. The selected input name appears in the display. 2 Press and hold down the input selector button selected in the Step 1 above for approximately 3 seconds to change the display name. 22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
22
Turning On the Receiver
For the TAPE and VCR/DVR buttons, the input display
name can be changed in the sequence as shown below.
When the input display name has been changed for one
of the buttons below, the display name for the other
button cannot be changed.
•
TAPE button
:
TAPE
→
MD
→
CDR
→
DOCK
•
VCR/DVR button
:
VCR/DVR
→
DOCK
ON/STANDBY
STANDBY indicator
ON/STANDBY
Turning On and Standby
1
Press the [ON/STANDBY] button.
Alternatively, press the remote
controller’s [ON/STANDBY]
button.
The receiver comes on, the display
lights up, and the STANDBY indicator
goes off.
To turn the receiver off, press the
[ON/STANDBY] button, or press the
remote controller’s [ON/STANDBY]
button. The receiver will enter Standby
mode. To prevent any loud surprises
when you next turn on the receiver,
always turn down the volume before
you turn it off.
or
Receiver
Remote
controller
Changing the Input Display
1
Press the appropriate input
selector button.
The selected input name appears in the
display.
2
Press and hold down the input
selector button selected in the
Step 1 above for approximately 3
seconds to change the display
name.
or