Onkyo 8555 Instruction Manual - Page 44

Controlling Other Components-Continued Programming a remote control code for controlling components connected via RI By default, the [DVD], [CD], and [DOCK] REMOTE MODE buttons have been programmed with the remote control codes for controlling Onkyo products. To control the components connected via RI, follow the steps below to program the appropriate remote control code for the component to be used. 1 Press and hold the [DVD], [CD], or [DOCK] REMOTE MODE button along with the [AUDIO] button for more than three seconds. and (3 seconds or more) 2 Select an appropriate 4-digit code from the list provided below, and then enter the code using the number buttons while the REMOTE MODE button is lit (for approximately 30 seconds). When a correct code is entered: The REMOTE MODE button quickly flashes twice, and programming completes. When an incorrect code is entered or an incorrect button is pressed: The REMOTE MODE button flashes once, and programming fails. Repeat steps 1 and 2. Remote control codes for controlling components connected via RI: [DVD]: 5002 (5001 by default) [CD]: 6002 (6001 by default) [DOCK]: 9002 (9001 by default) Resetting the REMOTE MODE Buttons You can reset a REMOTE MODE button to its default remote control code. 1 While holding down the REMOTE MODE button that you want to reset, press and hold down the [DISPLAY] button until the button REMOTE MODE button lights up (about 3 seconds). and (3 seconds) 2 Press the REMOTE MODE button again. The REMOTE MODE button flashes twice, indicating that the button has been reset. Each REMOTE MODE button is preprogrammed with a remote control code. When a button is reset, its preprogrammed code is restored. Resetting the Remote Controller You can reset the remote controller to its default settings. 1 and While holding down the [RECEIVER] REMOTE MODE button, press and hold down the [DISPLAY] button until the REMOTE MODE button lights up (about 3 seconds). (3 seconds) 2 Within 30 seconds, press the [RECEIVER] REMOTE MODE button again. The REMOTE MODE button flashes twice, indicating that the remote controller has been reset. 44