Onkyo 8555 Instruction Manual - Page 34
Advanced Setup Menu, Changing the Remote Controller's ID
UPC - 751398008313
View all Onkyo 8555 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Advanced Setup-Continued Advanced Setup Menu 1.Hardware set Remote ID When several Onkyo components are used in the same room, their remote ID codes may overlap. To differentiate the receiver from the other components, you can change its remote ID from 1, the default, to 2 or 3. Note: • If you do change the receiver's remote ID, be sure to change the remote controller to the same ID, otherwise, you won't be able to control it with the remote controller. Impedance See page 15. Z2 Out See page 36. 2.Intelli Vol With IntelliVolume, you can set the input level for each input selector individually. This is useful if one of your source components is louder or quieter than the others. Use the Left and Right [ ]/[ ] buttons to set the level. If a component is noticeably louder than the others, use the Left [ ] button to reduce its input level. If it's noticeably quieter, use the Right [ ] button to increase its input level. The input level can be adjusted from -12 dB to +12 dB in 1 dB steps. Note: • IntelliVolume does not apply for Zone 2. 3.Volume Setup Volume Disp (Volume Display) With this setting, you can select the Abs (Absolute) or Rel (Relative) volume display mode. Muting Lvl (Muting Level) With this setting, you can set the Muting Level. The range is -00dB, -50dB, -40dB, -30dB, -20dB, -10dB. MaxVolume (Maximum Volume) With this setting, you can limit the maximum volume. The Maximum Volume range is Off, 79 to 30. Pow On Vol (Power On Volume) This setting determines the volume level applied each time the receiver is turned on. The range is Last, Min, 1 to 79, Max. To use the same volume level as when the receiver was last turned off, select Last. Note: • The Power On Volume setting cannot be set higher than the Maximum Volume setting. Z2MaxVol (Zone 2 Maximum Volume) With this setting, you can limit the maximum volume for Zone 2. The Maximum Volume range is Off, 79 to 30. Z2POnVol (Zone 2 Power On Volume) This setting determines the volume level applied for Zone 2 each time the receiver is turned on. The range is Last, Min, 1 to 79, Max. To use the same volume level as when the receiver was last turned off, select Last. 4.Tuner Setup See "Using XM/SIRIUS Satellite Radio." 5.Lock Setup With this setting, you can protect your settings by locking the setup menus. Locked: Setup menus locked. Unlocked: Setup menus unlocked. When Locked is selected, only this Lock Setup item can be accessed. Changing the Remote Controller's ID 1 and While holding down the [RECEIVER] REMOTE MODE button, press and hold down the [SUBTITLE] button until the REMOTE MODE button lights up (about 3 seconds). (3 seconds) 2 Use the number buttons to enter ID 1, 2, or 3. The [RECEIVER] REMOTE MODE button flashes twice. If programming fails, the button flashes once. Repeat steps 1 and 2. 34