Onkyo HT-SR800 Owner Manual - Page 38
Using Audyssey 2EQ/HTIB, Press [ENTER].
View all Onkyo HT-SR800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
First Time Setup-Continued Using Audyssey 2EQ/HTIB 1 STANDBY/ON STANDBY TUNING PRESET MASTER VOLUME PHONES MULTI CH A SPEAKERS B DVD VCR/DVR CBL/SAT AUX TAPE TUNER C D SETUP ENTER RETURN TONE STEREO LISTENING MODE DISPLAY DIGITAL INPUT DIMMER MEMORY TUNING MODE CLEAR SETUP MIC AUX INPUT VIDEO L AUDIO R 2, 6 SETUP MIC 1 Turn on the AV receiver. 2 Put the speaker setup microphone at measurement point 1 (page 37), and connect it to the SETUP MIC jack. SETUP MIC Notes: • Make sure the microphone is horizontal. • If there's an obstacle between the micro- phone and any speaker, the automatic setup will not work correctly. Set up the room as you would when enjoying a DVD. • Positioning the microphone close to where your ears would normally be will provide better results. You can adjust the height of the microphone by using a tripod or level table. 3 Press [ENTER]. The automatic speaker setup starts. Notes: • If the AV receiver was previously muted, it will be unmuted. • Automatic speaker setup cannot be performed while a pair of headphones is connected. • It takes about 10 minutes to complete the auto- matic speaker setup. 4 When the following display appears, move the speaker setup microphone to measurement point 2 (page 37), and then press [ENTER]. Audyssey 2EQ/HTIB performs more measurements. This takes a few minutes. 5 When the following display appears, move the speaker setup microphone to measurement point 3 (page 37), and then press [ENTER]. Audyssey 2EQ/HTIB performs more measurements. This takes a few minutes. When the measurements are complete, the results are calculated and saved automatically. A test tone is output by each speaker in turn, as the Audyssey 2EQ/HTIB function determines which speakers are connected. This takes a few minutes. 6 When the automatic speaker setup is complete, disconnect the speaker setup microphone. Note: • If any extraneous noise is picked up by the microphone, the automatic setup may not work correctly, so don't make any noise. Notes: • When the automatic speaker setup is complete, the Equalizer Settings (page 60) will be set to "Audyssey." • You can cancel the automatic speaker setup at any point in this procedure simply by disconnecting the setup microphone. 38