Panasonic MC-UG323 Operating Instructions (Multi Language) - MCUG323 - Page 42

Replacing Belt, rotating upward.

Get Panasonic MC-UG323 PDF manuals and user guides View all Panasonic MC-UG323 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 42 highlights

3 2 1 ➢ Remove nozzle hose from body by (1) pressing in locking tab and (2) sliding up and out of retaining slot. ➢ Inspect inlet of nozzle hose and clear any obstructions. ➢ Replace nozzle hose by sliding down on retaining bracket until you hear a click. ➢ Return the vacuum cleaner to the upright position before plugging into an electrical outlet. Four Screws Quatre vis Cuatro Tornillos Replacing Belt ➢ Replace belt whenever a burning rubber smell caused by excessive slippage occurs. ➢ Turn off and unplug the vacuum cleaner. ➢ Lay unit on floor bottom up with nozzle flat. ➢ Remove nozzle hose from body by (1) pressing in locking tab and (2) sliding up and out of retaining slot (see REMOVING CLOGS, p. 40). ➢ Remove the four screws from the nozzle cover. Next place the vacuum in the upright position standing on the handle. This will minimize wheel interference when removing nozzle bottom plate. Remove nozzle bottom plate by rotating upward. CAUTION Motor shaft may be hot. - 42 -

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
- 42 -
Replacing Belt
Four Screws
Quatre vis
Cuatro Tornillos
➢
Replace belt whenever a burning
rubber smell caused by excessive
slippage occurs.
➢
Turn off and unplug the vacuum
cleaner.
➢
Lay unit on floor bottom up with
nozzle flat.
➢
Remove nozzle hose from body by
(1) pressing in locking tab and (2)
sliding up and out of retaining slot
(see REMOVING CLOGS, p. 40).
➢
Remove the four screws from the
nozzle cover. Next place the
vacuum in the upright position
standing on the handle. This will
minimize wheel interference when
removing nozzle bottom plate.
Remove nozzle bottom plate by
rotating upward.
CAUTION
Motor shaft may be hot.
➢
Remove nozzle hose from body by
(1) pressing in locking tab and (2)
sliding up and out of retaining slot.
➢
Inspect inlet of nozzle hose and
clear any obstructions.
➢
Replace nozzle hose by sliding
down on retaining bracket until you
hear a click.
➢
Return the vacuum cleaner to the
upright position before plugging
into an electrical outlet.
2
1
3