Pioneer AVH-P3200BT Owner's Manual - Page 72

Appendix Additional Information Troubleshooting Common Symptom Cause Action (Reference page) The power will not turn on. The unit will not operate. Leads and con- Confirm once more nectors are incor- that all connecrectly connected. tions are correct. The fuse is blown. Rectify the cause and then replace the fuse. Be sure to install a fuse with the same rating. Noise and/or Press RESET. (Page other factors are 10) causing the built- in microproces- sor to operate in- correctly. Operation with the remote control is not possible. The unit does not operate correctly even when the appropriate remote control buttons are pressed. Battery power is low. Some operations are prohibited with certain discs. Load a new battery. Try operating with another disc. Playback is not The disc is dirty. Clean the disc. possible. (Page 80) The type of disc Check the disc loaded cannot be type. played on this unit. The disc loaded Change the disc to is not compatible one that is compa- with this video tible with your system. video system. There is no sound. The volume level will not rise. Cables are not connected correctly. The unit is performing still, slow motion or frame-by-frame playback. Connect the cables correctly. There is no sound during still, slow motion or frameby-frame playback. Symptom Cause Action (Reference page) There is no image displayed. The parking brake cable is not connected. Connect the parking brake cable, and apply the parking brake. The parking brake is not applied. Connect the parking brake cable, and apply the parking brake. The icon is The operation is This operation is displayed, and prohibited for the not possible. operation is not disc. possible. The operation is This operation is not compatible not possible. with the config- uration of the disc. The image displayed stops (pauses) and the unit cannot be operated. The data could no longer be read during playback. Stop playback once, and start playback again. There is no sound. The volume level is low. The volume level Adjust the volume is low. level. The attenuator is Turn the attenuator on. off. The sound and The unit is not Firmly secure the video skip. firmly secured. unit. File size and Create a DivX file transmission rate that is within the are above recom- recommended size mended rates. and transmission rate. The aspect ratio is incorrect and the image is stretched. The aspect ratio setting is incorrect for the display. Select the appropriate setting for your display. (Page 59) The motor sounds when the ignition switch is turned ON (or is turned to ACC). The unit is confirming whether or not a disc is loaded. This is a normal operation. 72 En