Pioneer AVH-X6500DVD Owner's Manual - Page 46
Installing the microphone, Installation, DIN Rear-mount, Removing the unit, Fastening the front panel - radio
View all Pioneer AVH-X6500DVD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Section 24 Installation Installation 1 1 1 2 1 Side bracket (small) 2 Flush surface screw (5 mm × 6 mm) 2 Install the unit into the dashboard. Insert the mounting sleeve into the dashboard. And then secure the mounting sleeve by using a screwdriver to bend the metal tabs (90°) into place. 1 1 Use binding screws (4 mm × 3 mm) only. 2 Tighten two screws on each side. Use any of binding screws (4 mm × 3 mm), binding screws (5 mm × 6 mm) or flush surface screws (5 mm × 6 mm), depending on the shape of screw holes in the bracket. 1 182 53 2 3 4 1 Dashboard 2 Mounting sleeve 3 Side bracket 4 Screw (2 mm × 3 mm) DIN Rear-mount 1 Determine the appropriate position where the holes on the bracket and the side of the unit match. When installing in a shallow space, use the following screw holes. 46 En 2 3 1 Screw 2 Dashboard or console 3 Factory radio mounting bracket Note In some types of vehicles, discrepancy may occur between the unit and the dashboard. If this happens, use the supplied frame to fill the gap. Removing the unit Extend top and bottom of the trim ring outwards to remove the trim ring. And then loosen the screws (2 mm × 3 mm) to remove the mounting sleeve. ! When reattaching the trim ring, push the trim ring onto the unit until it clicks. (If the trim ring is attached upside down, the trim ring will not fit properly.) 1 2 3 1 Mounting sleeve 2 Screw (2 mm × 3 mm) 3 Trim ring Fastening the front panel If you do not plan to detach the front panel, the front panel can be fastened with supplied screw. Installing the microphone (Function of AVH-X7500BT) CAUTION It is extremely dangerous to allow the microphone lead to become wound around the steering column or shift lever. Be sure to install the unit in such a way that it will not obstruct driving. Note Install the microphone in a position and orientation that will enable it to pick up the voice of the person operating the system. When installing the microphone on the sun visor 1 Fit the microphone lead into the groove. 1 1 1 Screw 2 1 Microphone lead 2 Groove 2 Install the microphone clip on the sun visor. With the sun visor up, install the microphone clip. (Lowering the sun visor reduces the voice recognition rate.)