Pioneer DEH-P80MP Operation Manual - Page 54

Section 12 Initial Settings Adjusting initial settings 1 Initial settings lets you perform initial setup of different settings for this unit. 1 Function display Shows the function status. 1 Press SOURCE and hold until the unit turns off. 2 Press Multi-Control and hold until the clock appears in the display. 3 Turn Multi-Control to select one of the initial settings. Turn Multi-Control clockwise to switch between the functions in the following order: ClockWarning (warning tone)AUX (auxiliary input)Dimmer (dimmer)Brightness (brightness)REAR SP (rear output and subwoofer controller)Telephone (telephone muting/attenuation)Motion (motion screen)EVER-SCROLL (ever scroll) Auto Open (flap auto open) Use the following instructions to operate each particular setting. # To cancel initial settings, press BAND. Setting the clock Use these instructions to set the clock. 1 Use Multi-Control to select clock. Clock appears in the display. 2 Push Multi-Control left or right to select the segment of the clock display you wish to set. Pushing Multi-Control left or right will select one segment of the clock display: HourMinute As you select segments of the clock display the segment selected will blink. 3 Push Multi-Control up or down to set the clock. Pushing Multi-Control up will increase the selected hour or minute. Pushing Multi-Control down will decrease the selected hour or minute. Notes ! You can match the clock to a time signal by pressing Multi-Control.  If the minute is 0029, the minutes are rounded down. (e.g., 10:18 becomes 10:00.)  If the minute is 3059, the minutes are rounded up. (e.g., 10:36 becomes 11:00.) ! Even when the sources are off, the clock display appears on the display. Switching the warning tone If the front panel is not detached from the head unit within four seconds of turning off the ignition, a warning tone will sound. You can turn off the warning tone. 1 Use Multi-Control to select Warning. Warning appears in the display. 54 En