Pioneer VSX-D509S Owner's Manual - Page 41

Sound Modes ADVANCED THEATER mode ( Dolby/DTS mode) Switch on the Dolby/DTS mode by pressing the 2 surround button. When Dolby/DTS mode is ON, Dolby Pro Logic, Dolby Digital and DTS, and signal processing is performed automatically corresponding to the input signal. Use this button to cycle through the various modes. For all modes other than STANDARD, DSP is switched on and will appears in the diisplay. 1 22 SOURCE RECEIVER DVD RCV TV VCR MULTI CONTROL CD TUN CD-R TVC 1 2 3 7 4 ¢ 2 DSP TEST TONE CH SELECT CH LEVEL FL DIMMER 1 22 Î MULTI CONTROL DVD/LD TV/SAT VCR/DVR CD RECEIVER TUNER CD-R/ TAPE/MD TV CONT 2 DSP MODE MIDNIGHT 5.1CH 1 2 3 4 CHANNEL TEST SELECT TONE 5 6 SIGNAL ATT SELECT 7 8 CHANNEL LEVEL 9 0 EFFECT ‡ ENTER 10 DISC 2 /DTS Playing a Source 1 Press RCV. This sets the remote to select the sound mode. (On the D409 the button is called RECEIVER.) (You can skip this step when using the controls on the receiver.) 2 Switch the Dolby/DTS mode on and off by pressing 2 on the remote control or 2/ DTS on the front panel. Each press changes the display as follows. =STANDARD = MUSICAL = DRAMA (OFF) + EXPANDED + ACTION + Refer to page 36 for more details about each surround effect. memo • The effects of Dolby/DTS mode can be adjusted in the range of 10 to 90 by pressing EFFECT +/- (the default setting is 70). Also, the effect level can be set in each Dolby/DTS mode by pressing the EFFECT +/- button. The STANDARD mode cannot be changed. 4 3 SOURCE RECEIVER DVD RCV TV VCR MULTI CONTROL CD TUN CD-R TVC 1 MIDNIGHT 4 SIGNAL SELECT 7 +10 2 3 5.1CH ATT 5 6 EFFECT 8 9 DISC 0 ENTER CH SELECT CH LEVEL FL DIMMER LOUDNESS FUNCTION MUTING SETUP Î 2 3 3 2 MULTI CONTROL DVD/LD TV/SAT VCR/DVR CD RECEIVER TUNER CD-R/ TAPE/MD TV CONT 2 DSP MODE MIDNIGHT 5.1CH 1 2 3 4 CHANNEL TEST SELECT TONE 5 6 SIGNAL ATT SELECT 7 8 CHANNEL LEVEL 19 ¡ 0 EFFECT 4 ‡ E¢ NTER LOUDNESS FUNCTION MUTING RECEIVER FL DIMMER REMOTE SETUP MASTER VOLUME AUDIO/VIDEO PRE-PROGRAMMED REMOTE CONTROL UNIT 3 4 1 Turn on the power of the playback component. 2 Turn on the power of the receiver. Be sure that the standby indicator turns off on the front panel. 3 Press MULTI CONTROL buttons or the FUNCTION button to select the source you want to playback. If the DIRECT FUNCTION is OFF you have to use the FUNCTION button to select the source (see p.28). 4 If necessary, press SIGNAL SELECT to select the input signal corresponding to the source component (as above). 5 Start playback of the component you selected in step 1. 41 Operation