Ricoh C410DN Software User Guide - Page 211
Remote Maintenance by telnet, Using telnet
UPC - 026649025341
View all Ricoh C410DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 211 highlights
Remote Maintenance by telnet Remote Maintenance by telnet Important ❒ Remote Maintenance should be password-protected so that access is allowed to administrators only. ❒ The password is the same as the one of Web Image Monitor administrator. When the password is changed using "mshell", other passwords change also. ❒ Some commands cannot be used depending on your printer. Using telnet Follow the procedure below to use telnet. Important ❒ Only one user at a time can log on to perform remote maintenance. A Use the IP address or the host name of the printer to start telnet. % telnet "IP_address" B Enter your user name and password. 6 Contact your network administrator for information about the settings. C Enter a command. D Quit telnet. msh> logout The configuration message about saving the changes appears. E Enter "yes" to save the changes, and then press the {OK} key. If you do not want to save the changes, enter "no", and then press the {OK} key. To make further changes, enter "return" at the command line, and then press the {OK} key. Note ❒ If the message "Can not write NVRAM information" appears, the changes are not saved. Repeat the procedure above. ❒ When the changes are saved, the network interface board is reset automatically with that changes. ❒ When the network interface board resets, the print job in print process will be printed. However, print jobs in queue will be canceled. 199