Ricoh C410DN Software User Guide - Page 213
appletalk, autonet, View settings, Changing PAP timeout configuration, Configuration
UPC - 026649025341
View all Ricoh C410DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 213 highlights
Remote Maintenance by telnet Note ❒ The access range restricts computers from use of the machine by IP address. If you do not need to restrict printing, make the setting "0.0.0.0" for IPv4, and "::" for IPv6. ❒ Valid ranges must be from lower (start address) to higher (end address). ❒ If you are running IPv4 or IPv6, up to five access ranges can be registered and selected. ❒ IPv6 can register and select the range and the mask for each access ranges. ❒ IPv6 mask ranges between 1 - 128 can be selected. ❒ Up to five access ranges can be specified. The entry is invalid if the target number is omitted. ❒ You cannot send print jobs, or access Web Image Monitor and diprint from a restricted IP address. appletalk Use the "appletalk" command to view and configure Appletalk parameters. ❖ View settings msh> appletalk 6 • [2] means "active" and [0] means "inactive". • The default is [2]. ❖ Changing PAP timeout configuration msh> appletalk ptimeout value > 0 • Timeout value becomes effective. msh> appletalk ptimeout value = 0 • Timeout value becomes ineffective. autonet Use the "autonet" command to view and configure AutoNet parameters. ❖ View settings The following command displays the current AutoNet settings: msh> autonet ❖ Configuration You can configure AutoNet settings. msh> autonet {on|off} • {on} means "active" and {off} means "inactive". ❖ Current interface priority configuration display msh> autonet priority 201