Ricoh C410DN Software User Guide - Page 238

Monitoring and Configuring the Printer wiconfig Use the "wiconfig" command to make settings for IEEE 802.11b. ❖ View settings msh> wiconfig ❖ View IEEE 802.11b settings msh> wiconfig cardinfo • If IEEE 802.11b is not working correctly, its information is not displayed. ❖ Configuration msh> wiconfig "parameter" Parameter mode {ap|adhoc|802.11adhoc} ssid "ID value" 6 channel frequency "channel no." key "key value" val {1|2|3|4} 226 Value configured You can set the infrastructure mode (ap) , the 802.11 ad hoc mode (802.11adhoc), or the ad hoc mode (adhoc). The default is ad hoc mode. You can make settings for the SSID in the infrastructure mode. Usable characters are ASCII 0x20-0x7e (32 bytes). An SSID value is set automatically to the nearest access point if no setting is made. If no setting is made for the ad hoc mode, the same value as for the infrastructure mode or an ASSID value is automatically set. The default is blank. You can enable or disable the WEP function. To enable the WEP function, specify [on]; to disable it, specify [off]. To start the WEP function, enter the correct WEP key. The default is "11". You can specify the WEP key when entering in hexadecimal. With a 64-bit WEP, you can use 10 digit hexadecimals. With a 128-bit WEP, you can use 26 digit hexadecimals. Up to four WEP keys can be registered. Specify the number to be registered with "val". When a WEP is specified by key, the WEP specified by key phrase is overwritten. To use this function, set the same key number and WEP key for all ports that transmit data to each other. Put "0x"on the front of WEP key. You can omit the numbers with "val". The key number is set to 1 when making these omissions. The default is blank.