Samsung DV435GTGJRA/A1 User Manual Ver.1.0 (English, French, Spanish) - Page 22
U.s. Models, Risk Of Electric Shock
View all Samsung DV435GTGJRA/A1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Installing your dryer 5. Review the "Electrical requirements" section on page 17. BEFORE OPERATING OR TESTING, follow the grounding instructions in the "Grounding" section on page 17. U.S. MODELS: WARNING RISK OF ELECTRIC SHOCK - All U.S. models are produced for a 3-WIRE SYSTEM CONNECTION. The dryer frame is grounded to the neutral conductor at the terminal block. A 4-WIRE SYSTEM CONNECTION is required for new or remodeled construction, mobile homes, or if local codes do not permit grounding through neutral. If the 4-wire system is used, the dryer frame cannot be grounded to the neutral conductor at the terminal block. Refer to the following instructions for 3 and 4-WIRE SYSTEM CONNECTIONS. Remove the terminal block cover plate. Insert the power cord with a UL-listed strain relief through the hole provided in the cabinet near the terminal block. A strain relief must be used. Do not loosen the nuts already installed on the terminal block. Be sure they are tight. Use a 3/8" (1 cm) deep well socket. 6. Review the "Gas requirements" section on page 16. Remove the pipe thread protective cap. Apply a pipe joint compound or about 1 1/2 wraps of Teflon tape over all threaded connections. The pipe joint compound must be resistant to the actions of any liquefied petroleum gas. Connect the gas supply to your dryer. An additional fitting is required to connect the 3/4" (1.9 cm) female thread end of a flexible connector to the 3/8" (1 cm) male threaded end on the dryer. Securely tighten the gas line fitting over the threads. Turn on the gas supply. Check all gas connections for leaks using a soap solution. If bubbles appear, tighten the connections and recheck. DO NOT use an open flame to check for gas leaks. 22_ Installing your dryer DV435-02836G_EN_20120522.indd 22 2012-05-22 12:13:47