Sanyo PLC XU78 Owners Manual - Page 46

Setting Ceiling When this function is "On", the picture is top/bottom and left/right reversed. This function is used to project the image from a ceiling mounting the projector. Ceiling Rear When this function is "On", the picture is left/right reversed. This function is used to project the image to a rear projection screen. Rear Input search This function detects the input signal automatically. When finding a signal, the search will stop. Use the Point 7 8 buttons to select one of the following. Off . . . . . Input search does not work. On1 . . . . Input search works under the situation below. • When pressing the INPUT button on the top control. • When pressing the COMPUTER button or VIDEO button on the remote control. On2 . . . . Input search works under the situation below. • W h e n t u r n i n g o n t h e p r o j e c t o r w i t h pressing the POWER ON/STAND-BY button on the top control or on the remote control. • When pressing the COMPUTER button or VIDEO button on the remote control. • When missing the current input signal. ✳ • When pressing the INPUT button on the top control. ✳ If the No show or Freeze function is active, cancel it to activate the Input search. It is also unavailable when On-Screen menu is displayed. ✔ Note: • While Input search is set On1 or On2, the status of Input and Lamp are displayed every time the signal is switched. • Only the input source selected at the last time can be detected. • If any of the INPUT button on the top control or COMPUTER/VIDEO button on the remote control is pressed while Input search is on, Input search will stop and go back to the previous input signal. 46