Sanyo PLC XU78 Owners Manual - Page 48

Setting On start When this function is "On", the projector is automatically turned on just by connecting the AC power cord to a wall outlet. ✔ Note: • Be sure to turn the projector off properly (see "Turning Off the Projector" on page 19). If the projector is turned off in the incorrect sequence, the On start function does not operate properly. On start Lamp control This function allows you to change brightness of the screen. Normal . . . . . normal brightness Auto brightness according with the input signal Eco lower brightness reduces the lamp power consumption and extends the lamp life. Remote control This projector provides two different remote control codes: the factory-set initial code (Code 1) and the secondary code (Code 2). This switching function prevents remote control interference when operating several projectors or video equipment at the same time. When operating the projector in "Code 2", both the projector and the remote control must be switched to "Code 2". To change the code for the projector: Select either "Code 1" or "Code 2" in this Setting Menu. To change the code for the remote control: Press and hold both the MENU and IMAGE buttons together for 10 seconds or more. After changing the code, make sure the remote control operates properly. ✔ Note: If the batteries are removed from the remote control for a long period of time, the remote control code will be reset. Remote control Press and hold MENU and IMAGE buttons for more than 10 seconds. 48