Singer One Instruction Manual 3 - Page 12

ACCESSORIES (Continued) Transparent Bobbin BOBBINS Transparent, drop-in bobbin, shows thread supply at a glance. NEEDLES • Type 7O5 H needles for all-purpose sewing • Type 7O5 HS ball-point (yellow band) needles, for sewing knits and stretch fabrics. Type 7O5 H twin needle for decora' tive twin-needle stitching. Regular Needle Twin Needle Ball-point (Yellow Band) Needle Needle-Clamp Screw Needle Clamp Flat Side to Back Changing the Needle ATTACHING FEED-COVER PLATE 1. Raise presser foot. (You do not need to remove the foot). 2. Turn hand wheel toward you until is at its highest position. 3. Slide feed-cover plate under the presser foot, until securing pins are located directly over holes in needle plate. Then snap down. CHANGING THE NEEDLE The needle clamp is designed so that the needle can only be inserted with the flat side of the needle to the back. To change the needle: 1. Raise needle bar to its highest position, loosen needle-clamp screw, and remove needle. 2. Insert new needle in clamp, with the flat side of the needle to the back; push it up as far as it will go. 3. Tighten needle-clamp screw. 0 Salon and pgrge SpotA 'dors Detachable SPool Pin SPOOL HOLDERS The spool holders hold spools of various sizes in position on the horizontal spool pin. Because spool does not turn, thread unwinds smoothly. DETACHABLE SPOOL PIN The secondary detachable spool pin is used for twin-needle sewing.