Singer One Instruction Manual 3 - Page 49

removing bobbin case, face plate and bulb DANGER: Before removing bobbin case, face plate and light bulb disconnect power-line pulg from electri- cal supply. V Raise Presser Foot and Needle REMOVING AND REPLACING BOBBIN CASE • Raise the presser foot. • Turn hand wheel toward you until needle is above the presser foot. • Remove needle plate as instructed on page' 7. • Remove bobbin. To remove bobbin case, turn bobbin case holder to back as far as it will go. Lift out. bobbin case. To replace bobbin case, guide the forked end under the feed and then thaw the. bobbin case under the position plate as illustrated. Turn holder all the way forward to lock bobbin case in position. After locking bobbin case in position, check that bobbin case is not jammed, but has slight rotational movement. • Replace needle plate. • Fully close slide plate, Locking Pin • A. 0 Bobbin Case Holder Feed goo' ``;ice: 4000"0446,, IOW Position Plate REMOVING FACE PLATE • Loosen and remove screw and remove face plate by sliding it downward. Face Pate Top Cover REPLACRIC FACE PLATE • Slide face plate up so that rim is engaged und.e• edge of top cover. • Align screw hole at lower edge of plate with screw hole in machine and replace and tighten screw. Screw a 45