Singer One Instruction Manual 3 - Page 33

STITCH WIDTH Two stitch width settings are required for making buttonholes: one for side stitching and one for the bar tack. Two possible combinations are illustrated. I Selector Setting for Side Stitching Selector Setting for Bar Tack Selector Setting for Side Stitching Selector Setting for Bar Tack Procedure Set stitch length in 0-1 area of stitch length dial. Attach special purpose foot. Set the pattern selector at , needle position selector at Q , and stitch width selector at the width desired for the side stitching. Place work under needle, aligning center marking of buttonhole with center slot in the special purpose foot. Side Stitching Position needle in fabric at point A. Lower foot and stitch to end of marking. Leave needle in fabric at point B. Raise foot and pivot work on needle. Lower foot. Take one stitch without changing width setting, bringing work to point C. Bar Tack Adjust stitch width selector for bar tacks and take at least six stitches. Stop at point D. 11111117311111111111 A C B 29