Sony CX150 Operating Instructions - Page 42

Setting items Functions Initial setting ID Mode (VPL-CX125/ CX155/CW125 only) Assigns an ID number (1 to 3) to the projector when you All want control two or more projectors individually with the supplied Remote Commander. When this item is set to "1," you can control the projector with the Remote Commander with the ID MODE key set to "1." When it is set to "All," you can control all the projectors with the Remote Commander independently of the ID MODE keys of the Remote Commander. Direct Power On Set to "On" if you are using a circuit breaker to turn the Off power on/off the entire system. You can turn the power on/off without pressing the power key on the projector. High Altitude Set to "On" when the projector is used at an altitude of Off Mode 1,500 m or higher. Notes • The auto V Keystone adjustment may not correct the trapezoidal distortion perfectly, depending on the room temperature or the screen angle. • If you need fine adjustment when V Keystone is set to "Auto", press the KEYSTONE key on the control panel or the remote commander, and change the value. The setting mode will be temporarily changed to "Manual" from "Auto". • If you want restore the "Auto" setting, first switch the V Keystone setting to "Manual", then return it to "Auto". • When you want to apply the fine adjustment value the next time, change the V Keystone setting to "Manual" from "Auto". • If High Altitude Mode is set to "On" at an altitude under 1,500 m, the reliability of the lamp may be diminished. 42 The Installation Menu