Sony DCR-DVD910 Operating Guide - Page 119
Cleaning inside the viewfinder, On charging the pre-installed, rechargeable battery
UPC - 689466092851
View all Sony DCR-DVD910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
Cleaning inside the viewfinder Remove any dust from inside the viewfinder by following the steps below. 1 Pull out the viewfinder. 2 While pushing in the tab on the bottom of the viewfinder with a fine-tipped object such as a ball point pen, pull the eyecup block in the direction of the arrow to remove. 6 Attach the eyecup block to the viewfinder, pushing it straight on until it clicks. 3 Remove dust from the eyecup block with a camera blower, etc. 4 Press the viewfinder onto the body of the camcorder. 5 Remove dust from the inside area where the eyecup block was attached with a camera blower, etc. b Notes • The eyecup block is a precision part. Do not disassemble it further. • Do not touch the lens of the eyecup block. On charging the pre-installed rechargeable battery Your camcorder has a pre-installed rechargeable battery to retain the date, time, and other settings even when the POWER switch is set to OFF (CHG). The preinstalled rechargeable battery is always charged while your camcorder is connected to the wall outlet (wall socket) via the AC Adaptor or while the battery pack is attached. The pre-installed rechargeable battery will be fully discharged in about 3 months if you do not use your camcorder at all. Use your camcorder after charging the pre-installed rechargeable battery. However, even if the pre-installed rechargeable battery is not charged, the camcorder operation will not be affected as long as you are not recording the date. x Procedures Connect your camcorder to a wall outlet (wall socket) using the supplied AC Adaptor, and leave it with the POWER switch set to OFF (CHG) for more than 24 hours. Additional Information Continued , 119