Sony MZ-NF810CK Operating Instructions - Page 84

Messages, Set AVLS to AVLS OFF

Page 84 highlights

Messages If the following error messages flash in the display window, check the chart below. Error message Meaning/Remedy AVLS FULL BLANKDISC • AVLS is set to "AVLS ON" so that the volume will not increase anymore. , Set AVLS to "AVLS OFF" (page 65). • You tried to set the 21st bookmark. , You can set up to 20 bookmarks. Set bookmarks within 20. • An MD with no recording on it is inserted. BUSY • You tried to operate the recorder while it was accessing the recorded data. , Wait until the message goes out (in rare cases, it may take a few minutes). CannotCHG • You tried to charge at a place where the temperature is too high. , Charge the battery at a temperature of 5°C (+41°F) to +40°C (+104°F). Charging • The recorder is charging the rechargeable battery. DISC FULL ERROR • The remaining recording time on the disc is 12 seconds (SP stereo), 24 seconds (LP2 stereo or monaural), 36 seconds (LP4 stereo), or less. , Replace the disc. • There is an internal malfunction in the system. , Restart the operation by doing steps 1 to 3 on page 83. If the message appears again, please consult your nearest Sony dealer. GroupFULL • You tried to create the 100th group. , You can create up to 99 groups in a disc. Create groups within 99. Hi DC in • Voltage of the power supply is too high (The supplied AC power adaptor or the recommended car battery cord is not used). , Use the supplied AC power adaptor or the recommended car battery cord. HOLD LOW BATT • The recorder is locked. , Slide HOLD against the arrow to unlock the recorder (page 19). • Batteries are weak. , Charge the rechargeable battery or replace the dry battery (page 19). MEM OVER • You tried to record with the recorder placed where it receives continuous vibration. , Put the recorder on a stable place, and start recording again. 84

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128

84
Messages
If the following error messages flash in the display window, check the chart below.
Error message
Meaning/Remedy
AVLS
• AVLS is set to “AVLS ON” so that the volume will not increase
anymore.
,
Set AVLS to “AVLS OFF” (page 65).
FULL
• You tried to set the 21st bookmark.
,
You can set up to 20 bookmarks. Set bookmarks within 20.
BLANKDISC
• An MD with no recording on it is inserted.
BUSY
• You tried to operate the recorder while it was accessing the
recorded data.
,
Wait until the message goes out (in rare cases, it may take a
few minutes).
CannotCHG
• You tried to charge at a place where the temperature is too high.
,
Charge the battery at a temperature of 5°C (+41°F) to +40°C
(+104°F).
Charging
• The recorder is charging the rechargeable battery.
DISC FULL
• The remaining recording time on the disc is 12 seconds (SP
stereo), 24 seconds (LP2 stereo or monaural), 36 seconds (LP4
stereo), or less.
,
Replace the disc.
ERROR
• There is an internal malfunction in the system.
,
Restart the operation by doing steps 1 to 3 on page 83. If the
message appears again, please consult your nearest Sony
dealer.
GroupFULL
• You tried to create the 100th group.
,
You can create up to 99 groups in a disc. Create groups within
99.
Hi DC in
• Voltage of the power supply is too high (The supplied AC power
adaptor or the recommended car battery cord is not used).
,
Use the supplied AC power adaptor or the recommended car
battery cord.
HOLD
• The recorder is locked.
,
Slide HOLD against the arrow to unlock the recorder
(page 19)
.
LOW BATT
• Batteries are weak.
,
Charge the rechargeable battery or replace the dry battery
(page 19).
MEM OVER
• You tried to record with the recorder placed where it receives
continuous vibration.
,
Put the recorder on a stable place, and start recording again.