Sony RM-AV2100 Operating Instructions (primary manual) - Page 44
s 43 and 44., button to which want to assign
UPC - 027242612044
View all Sony RM-AV2100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Transferring Data between Remote Commanders (continued) 2 Press the m key. M: Transfer data m: Receive data 3 Press the 1 key. 1: All data of the Commander 2: Data of a Component Select button 4 Press the ENTER key. To receive the data of a Component Select button from another remote commander 1~2 Perform Steps 1 and 2 on pages 43 and 44. 3 Press the 2 key. 4 Press the Component Select button to which want to assign the data. 5 Press the ENTER key. As the data is received, the corresponding component name stays lit. If the all data have been successfully received, the backlight of the display turns off. Notes • If the Commander is not ready for receiving the data, press CLEAR key, then EXECUTE key to clear the learned signal on all or one of the Component Select buttons. • If "NG" appears during data transfer, go back to Step 3 and continue the operation or press COMMANDER OFF to stop the operation. If you continue the operation, you have to set the sending remote commander again to send data. When the data have been received, "TV" and "m" go off. If the data have been successfully received, the backlight of the display turns off. Notes • If the Commander is not ready for receiving the data, press CLEAR key, then EXECUTE key to clear the learned signal on all or one of the Component Select buttons. • If "NG" appears during data transfer, go back to Step 3 and continue the operation or press COMMANDER OFF to stop the operation. If you continue the operation, you have to set the sending remote commander again to send data. 44