Sony STR-DG600 Operating Instructions - Page 84
Specifications, AUDIO POWER - troubleshooting
View all Sony STR-DG600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
If you are unable to remedy the problem using the troubleshooting guide Clearing the receiver's memory may remedy the problem (page 30). However, note that all memorized settings will be reset to their factory settings and you will have to readjust all settings on the receiver. If the problem persist Consult your nearest Sony dealer. Note that if service personnel changes some parts during repair, these parts may be retained. Reference sections for clearing the receiver's memory To clear All memorized settings Customized sound fields See page 30 page 60 Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: (Models of area code U only) With 8 ohm loads, both channels driven, from 20 - 20,000 Hz; rated 100 watts per channel minimum RMS power, with no more than 0.09% total harmonic distortion from 250 milliwatts to rated output. Amplifier section Models of area code U, CA Stereo Power Output1), Reference Power Output1)2) 8 ohms 20 Hz - 20 kHz, THD 0.09% 100 W + 100 W, 110 W/ch 8 ohms 1 kHz, THD 0.7% 110 W + 110 W, 120 W/ch 8 ohms 1 kHz, THD 10% 125 W + 125 W, 150 W/ch 1)Measured under the following conditions: Area code Power requirements U, CA 120 V AC, 60 Hz 2)Reference power output for front, center, surround and surround back. Depending on the sound field settings and the source, there may be no sound output. 84US