Sony VGC-RA839G VAIO User Guide - Page 88
Replacing the drive holder
View all Sony VGC-RA839G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
10. Push the drive holder handle down to lock the drive into position. 11. Reconnect the SATA and power connectors to the original drive. 12. Connect another SATA interface cable between the new drive and an unused SATA port on the motherboard. 13. Connect the second power connector to the new drive following the instructions supplied with the drive. Replacing the driv e holder 14. Replace the side panel. See About Closing the Computer. 15. Reconnect the power cord to your computer. The hard disk drive access light blinks when either internal hard disk drive is active. Page 88
10.
Push the drive holder handle down to lock the drive into position.
11.
Reconnect the SATA and power connectors to the original drive.
12.
Connect another SATA interface cable between the new drive and an unused SATA port on the motherboard.
13.
Connect the second power connector to the new drive following the instructions supplied with the drive.
Replacing the drive holder
14.
Replace the side panel. See
About Closing the Computer
.
15.
Reconnect the power cord to your computer.
The hard disk drive access light blinks when either internal hard disk drive is active.
Page 88