TEAC DM-3200 DM-3200 Owner's Manual - Page 99
Location memories, Selecting the location point display, Storing a location memory “on the fly”
View all TEAC DM-3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
8 - Remote operation : Location memories Location memories The DM-3200 allows the storage and recall of up to ten location memories, allowing easy location of the controlled devices to predetermined cue points. Selecting the location point display As explained in "LOCATE DISPLAY mode" on page 33, the LOCATE DISPLAY MODE setting in the OPTION SETUP screen is used to determine whether the LED time counter shows the location memories as they are entered, edited and recalled, or whether they are shown as "popup" panels on the LCD display screen. When this section mentions "the display" showing location memory values, this refers to the display that has been selected in this option. NOTE Depending on the settings for frame display ("Edit Frames" on page 97), the frames value may or may not be shown on the display when location memories are being edited, etc. Storing a location memory "on the fly" This procedure allows you to set a location memory, regardless of whether timecode is currently being received or not. If timecode is not currently being received, the value of the location memory is the last received value as shown on the time counter on the display. The value on the time counter, regardless of source, is stored as the location memory. This may be timecode or MTC. 1 Press the MEMO key. The indicator starts to flash. 2 Press any of the numeric keys, corresponding to the ten location memories available. 3 The MEMO indicator stops flashing and the currently-displayed timecode value is stored in the location memory corresponding to the numeric key which was pressed. Manually entering and editing a location memory The procedure below can be used for editing existing checking and editing of another location mem- location memories or for adding new ones: ory. 1 Press the EDIT key. The indicator starts to flash. 4 Press the ENTER key when the timecode value for the location memory has been entered. 2 Press one of the number keys to select the location memory which will store the value. The EDIT indicator lights steadily. 5 Press EDIT again once to edit another location memory, or press EDIT twice to exit the location memory editing mode. 3 Enter the timecode value using the numeric keypad. The display shows the value, "filling up" from the right digit towards the left. Or, if the EDIT key is pressed again after the location memory number has been pressed, the indicator starts to flash again, allowing the If the CLR key is pressed before the ENTER key, a location memory entry which has been made in error is cleared. Pressing ENTER stores the cleared memory. It is possible to switch between the capture, edit and location procedures at any time. Location to a location memory When the location memories have been entered, they are recalled in the following way: 1 Press the DIRECT key. The indicator lights. 2 Press any one of the numeric keys, corresponding to the ten location memories. 3 The controlled device locates to the memory stored in the location memory. What happens next depends on the PLAY MODE setting (see "Play Mode" on page 97). TASCAM DM-3200 User's Manual 99