Toshiba 32HL85 Owners Manual - Page 24

Setting up your TV R Adding channels to the TV's memory When you press Channel y or z, your TV will stop only on the channels you programmed into the TV's channel memory. Follow the steps below and on the next page to program channels into the TV's memory. Programming channels automatically Your TV can automatically detect all active channels in your area and store them in the channel memory. After the channels are programmed automatically, you can manually add or erase individual channels (see page 25). To program channels automatically: 1. Press MENU, and then press x or • until the SET UP menu appears. 2. Press y or z to highlight TV/CABLE. 3. Press x or • to select either TV (if you use an antenna) or CABLE (if you use cable channels). SET UP 1/2 LANGUAGE TV/CABLE CH PROGRAM ADD/ERASE CH LABELING VIDEO LABEL ENGLISH CABLE ENTER ADD ENTER MENU BACK EXIT WATCH TV 4. Press z to select CH PROGRAM. Note: To tune the TV to a channel not programmed in the channel memory, you must use the Channel Number buttons on the remote control. TV/VIDEO RECALL POWER INFO 123 456 78 +10 100 0 U FAV 9 CHRTN ENT DVDMENU FAV CH VOL Channel Numbers MENU yzx • ENTER Channel yz SET UP 1/2 LANGUAGE TV/CABLE CH PROGRAM ADD/ERASE CH LABELING VIDEO LABEL ENGLISH CABLE ENTER ADD ENTER MENU BACK EXIT WATCH TV 5. Press ENTER to start channel programming. The TV will automatically cycle through every channel (TV or Cable, depending on which you selected in step 3), and store all active channels in the channel memory. While the TV is cycling through the channels, the message "Programming Now-Please Wait" appears. 6. When channel programming is complete, the message "Completed" appears. 7. Press Channel y or z to view the programmed channels. 24