Toshiba Tecra A8 Maintenance Manual - Page 144

3 Tests and Diagnostics 3.3 Setting of the hardware configuration Subtest 03 Subtest 04 7. "Create DMIINFO TXT (Y/N) ?" is displayed. Press Y, then the DMI information (text data) is written to the Floppy disk, etc. • Setting of the HWSC • Setting of the UUID • Display of the DMI information (including UUID) After completion of the above settings, H/W configuration & DMI information are appeared in order. Check the contents and press Enter. DMI information save This is one of tools to copy the DMI information to a new PCB after replacing. This subtest saves all the DMI data in a floppy disk. DMI information recovery This is one of tools to copy the DMI information to a new PCB after replacing. This subtest writes all the DMI data in the floppy disk into the new PCB. NOTE: Since the data of UUID is updated every time when this subtest, DMI information recovery, is done, the saved UUID data is not written. Subtest 08 Subtest 09 System configuration display This subtest displays the information of the system configuration. When the following message appears, confirm the contents and press Enter. Press [Enter] key For more details on the system configuration information, refer to "3.25 System configuration". E2PROM test (MAC/GUID/DMI) It checks whether the MAC address, GUID of IEEE1394 and DMI information are written. 3-10 [CONFIDENTIAL] TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573)