Toshiba Tecra A8 Maintenance Manual - Page 276

4 Replacement Procedures 4.10 Cover assembly Installing the Cover assembly To install the cover assembly, follow the steps below and refer to Figure 4-15 to 4-17. 1. Place the cover assembly on the base assembly and secure the latches. 2. Secure the cover assembly with the following screw and stick the glass tape. • M2.5×6B FLAT HEAD screw ×1 3. Connect the touch pad cable, fingerprint sensor cable, speaker cable, Bluetooth cable and LCD cable to the connector CN3240, CN9700, CN6170, CN4400 and CN5000 on the system board. 4. Connect the SD card slot cable and SW membrane cable to the connector CN9720 and CN9721 on the system board. and stick the insulator. 5. Close the display and turn over the computer. 6. Secure the cover assembly with the following screws. • M2.5×5B FLAT HEAD screw ×1 ("5" in the figure 4-15) • M2.5×6B FLAT HEAD screw ×11 ("6" in the figure 4-15) • M2.5×10B FLAT HEAD screw ×3 ("10" in the figure 4-15) • M2.5×16B FLAT HEAD screw ×3 ("16" in the figure 4-15) 4-30 [CONFIDENTIAL] TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573)