Viking VIPR161SS Installation Instructions - Page 11

VIKING RANGE CORPORATION Downdraft Ventilators OPERATION UP / DOWN-----Raises and lowers vent. All Units Turns blower ON when vent is UP and OFF when REMOTE CONTROL vent is DOWN. FOR MODELS Note: The UP/DOWN switch for models VIPR102SS, VIPR162SS, and VIPR182SS is on the right hand end of VIPR102RSS VIPR162RSS the top cover. VIPR182RSS DELAY-----------Allows blower to run for 10 min. after button is pressed. Delay is activated by double pressing any speed control button. Blower will run for 10 min. - then shut OFF. VENT WILL NOT LOWER.You must press UP / DOWN to lower vent. When DELAY is activated, the speed level light will blink. BLOWER SPEEDS ------Blower operates at 4 different speed levels. Press button ONCE to turn blower ON to desired speed. Press button AGAIN to turn blower OFF. FILTER LIGHT Comes ON after 30 hours of operation to remind you to clean filters. Press button to reset. REFSILETTER 1234 USE AND CARE FILTER UP DOWN 1234 U P/D O W N TOP COVER CONTROL FOR MODELS VIPR102SS VIPR162SS VIPR182SS Always turn the downdraft blower on before you begin cooking to All Units Wash the 2 aluminum/stainless steel grease filters in a mild de- establish an air flow in the kitchen. tergent solution or a dishwasher. Let the blower run for a few minutes Remove them from the air vent to clean the air after you turn the cooktop off.This will keep the whole WARNING: Always disconnect electric power by grasping the tab at the top of supply before cleaning and/or servicing unit. each filter. kitchen cleaner and brighter. The activating switch is pressed and Servicing the air vent rises. It may be necessary to remove the downdraft blower system from Cleaning the cabinet in order to service components such as the blower motor or air vent mechanism. Use a mild detergent suitable for painted surfaces. DO NOT USE ABRASIVE CLOTH, STEEL WOOL PADS, OR SCOURING POWDERS. Vacuum blower to clean. Do not immerse blower in water. Disconnect power to the cooktop and remove it first. Reverse the steps under "MOUNT THE UNIT" to remove the downdraft from the cabinet. 11