Viking VIPR161SS Installation Instructions - Page 2
Interior Blower Installation, Exterior Blower Installation, All Units - downdraft #
View all Viking VIPR161SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
VIKING RANGE CORPORATION Downdraft Ventilators PLANNING Interior Blower Installation This downdraft blower system is designed to be used to exhaust airborne contaminants when cooking with a variety of gas or electric cooktops. It can be mounted in island, peninsula, or conventional wall locations. This unit can be easily installed following these basic steps: • Cut out the countertop opening. • Mount the unit in the cabinet. • Install the Model VIDV500 Interior Blower • Connect the ductwork and electrical. • Install the cooktop. Note: the high level of air flow of this appliance may effect the gas flame on some types of gas cooktops. This is NORMAL and will cause no harm, but can be corrected by lowering the speed of the blower. TYPICAL INSTALLATION COUNTER CHIMNEY TOP TOP COOK TOP GEAR MOTOR COVER BLOWER BOX AIR VENT 120 VAC GROUNDED OUTLET 3-1/4" X 10" DUCT CONNECTOR ELECTRICAL SPECIFICATIONS 120 VAC • 60 Hz • 4.0 A TAKE MEASUREMENTS Exterior Blower Installation This downdraft blower system is designed to be used to exhaust airborne contaminants when cooking with a variety of gas or electric cooktops. It can be mounted in island, peninsula, or conventional wall locations. TYPICAL INSTALLATION COUNTER TOP CHIMNEY TOP COOK TOP GEARMOTOR COVER AIR VENT This unit can be easily installed following these basic steps: • Cut out the countertop opening. • Mount the unit in the cabinet. 10" ROUND DISCHARGE PLATE 120 VAC GROUNDED OUTLET • Install 10" round discharge plate 10" ROUND DUCTWORK • Install Model VEDV900 or VEDV1200 (48" Model ONLY) External Blower ELECTRICAL SPECIFICATIONS • Connect the ductwork and electrical. 120 VAC • 60 Hz • 6.0 A (max.) • Install the cooktop. Note: the high level of air flow of this appliance may effect the gas flame on some types of gas cooktops. This is NORMAL and will cause no harm, but can be corrected by lowering the speed of the blower. All Units 1. Refer to the cooktop installation instructions for dimensions of cooktop, countertop cut-out, and cabinet requirements. The Models VIPR102SS and VIPR102RSS will fit in most 30" wide cabinets the Models VIPR162SS and VIPR162RSS will fit in most 36" wide cabinets and the Models VIPR182SS and VIPR182RSS will fit most 48" wide cabinets. However, it is recommended that oversized cabinets be used for easier installation. 2. Cooktop depth can vary greatly from one to another. This may cause the fit of these two appliances to be rather tight. Pay special attention to the areas of potential interference highlighted above. A countertop with (A) a raised lip and/or (B) a backsplash may not allow enough flat countertop for a proper installation. Note that 2" of flat countertop is required behind cooktop and that 1-3/4" is necessary between the back edge of the cooktop and the inside of cabinet back. 2