Weider Pro 9450 Uk Manual - Page 10

12. Press a 1" Round Inner Cap (49) into one of the 12 Press Arms (46). Press a 1 3/4" Square Inner Cap (44) into the Press Arm. 44 49 Attach the Press Arm (46) to one side of the Press 46 Frame (17) with two 5/16" x 2 1/2" Bolts (22) and two 5/16" Nylon Locknuts (3). 22 Assemble the other Press Arm (46) in the same manner. 46 3 17 13. Identify the Right Arm (48) and the Left Arm (47). Note the position of the welded bracket on each Arm. Arm identification is very important for step 14. Attach a "V"-Pulley (50) and a Long Cable Trap (31) to the Right Arm (48) with a 3/8" x 2 1/2" Bolt (86) and a 3/8" Nylon Locknut (21). Do not tighten the Nylon Locknut yet. 13 86 31 50 Welded Brackets 31 50 47 21 Attach a "V"-Pulley (50) and a Long Cable Trap (31) to the Left Arm (47) in the same manner. 48 14. Lubricate both axles on the Top Frame (55). 14 Slide the Right Arm (48) onto the right axle on the Top Frame (55). Note: Be careful not to confuse the Right Arm with the Left Arm (47); refer to step 13 to identify the Right Arm. Be sure that the upper end of the Right Arm is behind the indicated bracket on the Top Frame. See the inset drawing. Tap two 1" Retainers (69) and a 1" Round Cover Cap (70) onto the axle. Be 48 sure that the teeth on the Retainers bend toward the Round Cover Cap, as shown. Attach the Left Arm (47) in the same manner. Press 1 3/4" Square Inner Caps (44) into the lower ends of the Right and Left Arms (47, 48). Wet the lower end of each Arm with soapy water. Slide a 10" Pad (45) onto the lower end of each Arm. 44 45 55 Bracket 47 Lubricate Axle 69 45 70 44 Axle 69 70 10