Weider Pro 9450 Uk Manual - Page 23

32. Wrap the Military Press Cable (72) around a 3 1/2" Pulley (15). Attach the Pulley and a pair of Pulley Covers (77) to the Pivot Arm (80) with the 3/8" Washer (9) and the 3/8" x 5 1/4" Bolt (101). Be sure the Washer and Bolt are on the side shown, and that the large tabs on the Pulley Covers are on top. Do not attach a Locknut yet. See the inset drawing. Wrap the Military Press Cable (72) around a 3 1/2" Pulley (15). Attach the Pulley and a pair of Pulley Covers (77) to the upper hole in the Long "U"-Bracket (57) with a 3/8" x 2" Bolt (12) and a 3/8" Nylon Locknut (21). Make sure the small tabs on the Pulley Covers are on the side shown. See the inset drawing. Wrap the Military Press Cable (72) around another 3 1/2" Pulley (15). Attach the Pulley and a pair of Pulley Covers (77) to the 3/8" x 5 1/4" Bolt (101) on the other side of the Pivot Arm (80) with a 3/8" Washer (9) and a 3/8" Nylon Locknut (21). Be sure that the Cable is routed as shown. Make sure the large tabs on the Pulley Covers are on the side shown. See the inset drawing. 32 101 9 77 15 77 72 77 57 Large Tabs 80 15 77 9 21 Small Tabs 77 15 21 77 57 12 33. Wrap the Military Press Cable (72) around a 3 1/2" 33 Pulley (15). Attach the Pulley and a Cable Trap (66) to the Leg Press Upright (56) with a 3/8" x 2" Bolt (12) and a 3/8" Nylon Locknut (21). 56 21 66 72 15 12 34. Lay the Military Press Cable (72) over a 3 1/2" 34 Pulley (15). Attach the Pulley and a pair of Pulley Covers (77) to the Leg Press Upright (56) with a 3/8" x 3 3/4" Bolt (88), two 3/8" Washers (9), and a 3/8" Nylon Jam Nut (99). Make sure the small tabs on the Pulley Covers are on the side shown. See the inset drawing. Make sure that the Military Press Cable (72) is between the 3 1/2" Pulley (15) and the post. Be sure that the Cable and Pulley move smoothly. 99 72 9 Post 15 77 9 88 Small Tabs 56 16