Weider Pro 9450 Uk Manual - Page 29

ATTACHING AND REMOVING THE SEAT To attach the Seat (13), slide one of the three slots in the bracket on the Front Seat Frame (36) onto the pin on the Front Upright (42). (Note: The Seat can be attached at three different heights.) Secure the Front Seat Frame to the Front Upright with the 5/16" x 2 3/4" Carriage Bolt (14), a 5/16" Washer (8), and the Seat Knob (40). For some exercises, the Seat (13) must be removed. First, be sure that the chain is not attached to the leg lever. Remove the Seat Knob (40), the 5/16" Washer (8), and the 5/16" x 2 3/4" Carriage Bolt (14), and lift the Front Seat Frame off the Front Upright (42). ATTACHING THE LEG LEVER TO THE LOW PULLEY STATION To use the Leg Lever (29), the seat must be attached to the front upright (see ATTACHING AND REMOVING THE SEAT above). Attach one end of the Chain (52) to the Low Cable (23) with a Cable Clip (53). Attach the other end of the Chain to the 3/8" x 2" Eyebolt (35) with a Cable Clip. ADJUSTING THE LEG PRESS PLATE Remove the Press Pin (97) from the Leg Press Plate (95) and the Leg Press Arm (96). Align the welded tubes on the Leg Press Plate (95) with the desired set of holes in the Leg Press Arm (96). Re-insert the Press Pin (97) through the welded tubes on Leg Press Plate and the holes in the Leg Press Arm. 42 8 40 36 13 14 Pin 53 29 52 35 53 23 Welded Tube 96 95 97 LOCKING THE WEIGHT STACK To prevent unauthorised use of the home gym system, insert the Locking Pin (104) into the indicated hole in one of the Weight Guides (62 or 73) and secure the Locking Pin with the Lock (105). Remove the Locking Pin (104) before using the weight system again. 62 73 Hole 105 104 22