Weider Pro 9450 Uk Manual - Page 24

35. Locate the Leg Press Cable (78). Attach the end of the Leg Press Cable to the Long "U"-Bracket (57) with a 1/4" Nylon Locknut (2) and a 1/4" Washer (10). Do not completely tighten the Nylon Locknut. It should be threaded onto the end of the Cable only a couple of turns, as shown in the inset drawing. Wrap the Leg Press Cable (78) around a 3 1/2" Pulley (15). Attach the Pulley and a set of Pulley Covers (77) to the Leg Press Upright (56) with the 3/8" x 3 3/4" Bolt (88), two 3/8" Washers (9), and a 3/8" Nylon Jam Nut (99). Be sure that the Cable and Pulley move smoothly and that the Cable is between the Pulley and the welded rod. The ball on the Cable must be on the indicated side of the Pulley. Be sure the large tabs on the Pulley Covers are on the indicated side. 35 2 10 77 57 9 15 77 88 Large Tab 78 Welded Rod 56 Ball 9 99 78 36. Attach the Press Bracket (94) to the Leg Press Arm 36 (96) with a 3/8" x 3" Bolt (100) and a 3/8" Nylon Jam Nut (99). Wrap the Leg Press Cable (78) around a 3 1/2" Pulley (15). Attach the Pulley and a set of Pulley Covers (77) to the Press Bracket (94) with a 3/8" x 2" Bolt (12) and a 3/8" Nylon Jam Nut (99). Be sure the small tabs on the Pulley Covers are in the position shown. Slide a 5/16" Washer (8) onto a 5/16" x 2 3/4" Bolt (11). Insert the Bolt through the centre hole in the Leg Press Seat Frame (79) from the indicated side. (Note: The three holes are for cable adjustment.) Tighten a 5/16" Washer (8) and a 5/16" Nylon Jam Nut (93) onto the Bolt. Slide the end of the Leg Press Cable (78) onto the end of the Bolt. Thread another 5/16" Nylon Jam Nut onto the Bolt. Do not fully tighten the second Jam Nut; there must be room between the two Jam Nuts for the end of the Cable to pivot. 2 10 57 96 Small 99 12 11 Tab 77 8 78 100 15 94 99 77 8 79 93 17