Weslo Gym 1500 Uk Manual - Page 5

ASSEMBLY Make Things Easier for Yourself Everything in this manual is designed to ensure that the weight system can be assembled successfully by anyone. However, it is important to realise that the weight system has many parts and that the assembly process will take time. Most people find that by setting aside plenty of time, assembly will go smoothly. • Assembly requires two persons. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. • Tighten all parts as you assemble them, unless instructed to do otherwise. • As you assemble the weight system, make sure all parts are oriented as shown in the drawings. • For help identifying small parts, use the PART IDENTIFICATION CHART at the centre of this manual. The following tools (not included) are required for assembly: • Two adjustable spanners • One rubber mallet • One standard screwdriver • One Phillips screwdriver • Lubricant, such as grease or petroleum jelly, and soapy water. Assembly will be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches. Frame Assembly 1. Before beginning assembly, be sure that you have read and understand the information in the box above. Press a 50mm Square Inner Cap (51) into the end of the Base (1). Press a 50mm Square Outer Cap (41) onto the ends of the Stabiliser (2). 1 41 41 2 68 1 Indents 56 Insert four M10 x 65mm Carriage Bolts (56) up through the Base (1) and the Stabiliser (2). Note: The indents around the holes in the Stabiliser must be on bottom. 56 51 Slide the bracket on the Base (1) onto the M10 x 65mm Carriage Bolts (56) in the Stabiliser (2). Hand tighten two M10 Nylon Locknuts (68) onto each Carriage Bolt. Do not tighten the Nylon Locknuts yet. 5